当前位置： SCI文献检索 > Scientific Reports期刊下所有文献 > Coating Cutting Blades with Thin-Film Metallic Glass to Enhance Sharpness.

Coating Cutting Blades with Thin-Film Metallic Glass to Enhance Sharpness.

Abstract：

:In this study, we sought to enhance the cutting properties of the various blades by coating them with Zr- and Fe-based thin film metallic glasses (TFMGs) to a thickness of 234-255 nm via sputter deposition. In oil-repellency/sliding tests on kitchen blades, the sliding angle and friction forces were as follows: bare blades (31.6°) and (35 µN), Ti-coated blades (20.3°) and (23.7 µN), and Z-TFMG coated blades (16.2°) and (19.2 µN). Comparisons were conducted with bare blades and those with a Teflon coating (a low-friction material commonly used for the coating of microtome blades). We also found that the Teflon coating reduced the cutting forces of an uncoated microtome blade by ~80%, whereas the proposed Z-TFMG achieved a ~51% reduction. The Z-TFMG presented no indications of delamination after being used 30 times for cutting; however, the Teflon coating proved highly susceptible to peeling and the bare blade was affected by surface staining. These results demonstrate the efficacy of the TFMG coating in terms of low friction, non-stick performance, and substrate adhesion. The performance of Z-TFMG and F-TFMG was also evaluated in split-thickness skin graft surgery using dermatome blades aimed at elucidating the influence of TFMG coatings on the healing of surgical incisions. When tested repeatedly on hairless skin, the surface roughness of uncoated blades increased by approximately 70%, whereas the surface roughness of TFMG-coated blades increases by only 8.6%. In the presence of hair, the surface roughness of uncoated blades increased by approximately ~108%, whereas the surface roughness of TFMG-coated blades increases by only ~23%. By Day 7, the wounds produced using TFMG-coated blades were noticeably smaller than those produced using uncoated blades, and these effects were particularly evident in hairy samples. This is a clear demonstration of the efficacy of TFMG surface coatings in preserving the cutting quality of surgical instruments.

journal_name

Sci Rep

journal_title

Scientific reports

authors

Chu JP,Diyatmika W,Tseng YJ,Liu YK,Liao WC,Chang SH,Chen MJ,Lee JW,Jang JSC

doi

10.1038/s41598-019-52054-3

subject

Has Abstract

pub_date

2019-10-29 00:00:00

pages

15558

issue

issn

2045-2322

pii

10.1038/s41598-019-52054-3

journal_volume

pub_type

杂志文章

在线工具

Coating Cutting Blades with Thin-Film Metallic Glass to Enhance Sharpness.