当前位置： SCI文献检索 > INTERNATIONAL ORTHOPAEDICS期刊下所有文献 > Accuracy of the correction obtained after tibial valgus osteotomy. Comparison of the use of the Hernigou table and the so-called classical method.

Accuracy of the correction obtained after tibial valgus osteotomy. Comparison of the use of the Hernigou table and the so-called classical method.

Abstract：

INTRODUCTION:Medial valgus-producing tibial osteotomy (MVTO) is classically used to treat early medial femorotibial osteoarthritis. Long-term results depend on the mechanical femorotibial angle (HKA) obtained at the end of the procedure. A correction goal between 3 and 6° valgus is commonly accepted. Several planning methods are described to achieve this goal, but none is superior to the other. OBJECTIVE:The main objective was to compare the accuracy of the correction obtained using either the Hernigou table (HT) or a so-called conventional method (CM) for which 1° of correction corresponds to 1° of osteotomy opening. The secondary objective was to analyze the variations observed in the sagittal plane on the tibial slope and on the patellar height. The working hypothesis was that the HT allowed a more accurate correction and that the tibial slope and patellar height were modified in both groups. MATERIAL AND METHOD:In this monocentric and retrospective study, two senior surgeons operated on 39 knees (18 in the CM group, 21 in the HT group) between January 1, 2009 and December 31, 2014. The operator was unique for each group and expert in the technique used. The correction objective chosen for each patient, and written in the operative report, was considered as the one to be achieved. The surgical correction was the difference between the pre-operative and immediate post-operative data (< 5 J) for the mechanical tibial angle (MTA) and the hip-knee-ankle (HKA) angle. Surgical accuracy, where a value close to 0 is optimal, was the absolute value of the difference between the surgical correction performed and the goal set by the surgeon. RESULTS:The median surgical accuracy on the MTA was 3.5° [0.2-7.4] versus 1.4° [0-4.1] in the CM and HT groups, respectively (p = 0.006). In multivariate analysis, with the same objective, the CM had a significantly lower accuracy of 1.9° ± 0.8 (p = 0.02). For HKA, the median accuracy was 3.1° [0.3-7.3] versus 0.8° [0-5] in the CM and HT groups, respectively (p = 0.006). Five (5/18, 28%) and 16 (16/21, 76%) knees were within 3° of the target in the CM and HT groups, respectively (p = 0.004). The median tibial slope increased in both groups. This increase was significantly greater in the CM group compared with the HT group, with 5.5° [- 0.3-13] versus 0.5 [- 5.2-5.6], respectively (p < 0.001). The median Caton-Deschamps index decreased (patella lowered) in both groups after surgery, by - 0.21 [- 1.03; - 0.05] and - 0.14 [- 0.4-0.16], but without significant difference (p = 0.19). In univariate analysis, changes in tibial slope and patellar height were not significantly related to frontal surgical correction performed according to ΔMTA (R2 = 0.07; p = 0.055) and (R2 = - 0.02; p = 0.54) respectively. DISCUSSION:The correction set by the surgeons was achieved with greater accuracy and more frequently in the HT group, confirming the working hypothesis. The HT is therefore recommended as a simple way of achieving the set objective; the tibial slope and patellar height were modified unaffected by the frontal correction performed.

journal_name

Int Orthop

journal_title

International orthopaedics

authors

Nicolau X,Bonnomet F,Micicoi G,Eichler D,Ollivier M,Favreau H,Ehlinger M

doi

10.1007/s00264-020-04777-6

subject

Has Abstract

pub_date

2020-12-01 00:00:00

pages

2613-2619

issue

eissn

0341-2695

issn

1432-5195

pii

10.1007/s00264-020-04777-6

journal_volume

pub_type

杂志文章

在线工具

Accuracy of the correction obtained after tibial valgus osteotomy. Comparison of the use of the Hernigou table and the so-called classical method.